![]() Click Remove to clear any of the domain servers from the list.Click Modify if you wish to make changes to any of the domain servers in the list.A specific server can only be added once to the list. Click OK to add it to the domain controller list.Enter the Application partition for the directory of users, or click Browse to select from a list of partitions.(A domain controller refers to a server shared by a group of computers that use a common accounts database.) The fully qualified domain name-not the IP address-must be entered for the Domain Controller. Enter the Domain Controller server name.Above the tree view in the Servers and containers group, click Add server.In System Manager, navigate to Configuration > Directory Services synchronization and select the Active Directory tab.To configure active directory synchronization, do the following: Synchronization, settings and any related operations available in this window can be applied to servers or individual containers, depending on your selection. You can see the result of the task in the System Manage-the list of users populates automatically when the task is complete.Īn Active Directory server consists of containers that contain records (users, computers, printers, etc.) organized by type, geographical location or similar. Performing these steps causes a task to run in the background. It is important to select options in the correct order in the Directory Services synchronization dialog box. DocuShare Enterprise Content Management.RF-programmable, 125 kHz, charcoal gray, customer-specified ID Numbers. RF-programmable 125kHz, customer-specified ID numbers, location marked for vertical slot punch. RF-programmable, 125 kHz, customer-specified ID numbers, locations marked for horizontal and vertical slot punch. RF-programmable, 125 kHz, customer-specified numbers. See the Related Content for additional information on How To Determine HID Card Encoding. For this reason, it is not always possible to infer the facility or ID codes from card labels, nor can you infer the type of encoding used on the cards based on the numbers printed on the exterior. ![]() Other may choose to obfuscate the data for security reasons and omit labels completely, or label the cards with a randomly generated serial number. Some organizations may choose to deploy cards with labels that clearly display the Facility and ID codes stored on the card. These numbers do not directly relate to the data stored on them. However, since the control terminals have HID readers using a 125KHz carrier frequency, only certain card formats can be read by the control terminal.Īll cards have the following numbering system printed on them for distribution purposes: HID offers a variety of products using different carrier frequencies and standards (HID IClass cards, HID Corporate 1000, HID Mifare, and others). The RF signal used to exchange information between the powered card reader and the passive card can operate at many different frequencies and ranges (125 KHz carrier frequency, or Mifare and Legic standard using a 13.56 MHz carrier frequency). However, refer to the HID Web site in case of discrepancy. The illustrations shown for each card is from HID's product data sheets. The following is a list of supported HID card formats.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |